Enable And Disable A Touchscreen In Windows

Browse technical resources about passive optical networks, ODN components, FTTR, PLC splitters, fiber distribution, and FTTH access.

  • Enable attack protection on core switches

    Enable attack protection on core switches

    Just like DHCP snooping, enable ARP inspection in the global configuration mode on the switch. Secondly, go to interface mode and configure those ports as trustworthy that are connected to the core devices, such as routers, firewalls, or servers. It encrypts management traffic, protecting login credentials and administrative commands from interception. Using SSH instead of Telnet ensures that all management sessions are encrypted, which is an. This document describes the Spanning Tree Protocol (STP) root guard feature that enhance switched network reliability and manageability. There are no specific requirements for this document. Sophos Switch can monitor and block denial-of-service (DoS) attacks. If too many MACs appear or an unexpected MAC is detected, the port goes into an err-disabled state, as shown in the.

    [PDF Version]
  • How to enable the optical module after plugging it into the optical port

    How to enable the optical module after plugging it into the optical port

    Align the SFP module with the optical port and insert it horizontally, pressing firmly until the bottom of the module engages with the locking spring of the optical interface. Figure 1 SFP Optical Module Installation. The Cisco Small Business Series Switches allow you to plug in a Small Form-factor Pluggable (SFP) transceiver in their optical modules to connect fiber optic cables. Once the transceiver and fiber optic cable are plugged in properly in the switch optical module, you should be able to view the. This section describes how to install optical transceivers on the SFP or SFP+ ports and connect them to the ports of the peer device using optical fibers according to the network plan. The USG supports both 1 Gbit/s, 10 Gbit/s, and 40 Gbit/s optical modules. The LED will only light up when all connections are properly established and functioning correctly. The installation process can be taken by the following instructions.

    [PDF Version]
  • How to disable a relay protection device

    How to disable a relay protection device

    A relay attack usually involves two people working together. One stands by the targeted vehicle, while the other stands near the house with a device that can pick up a signal from the key fob. What's more, s.


Passive Optical Network & FTTR Insights

Need Professional Passive Optical or FTTR Solutions?

Contact us today for product inquiries, custom designs, or technical support