Guide How to Install or Remove SFP, SFP+, QSFP, and XFP Modules
To safely remove an SFP module, follow these steps: Disable the port in your network device settings or power off the device to avoid electrical damage. Disconnect the optical cable.
Guide SFP Insertion & Removal
To remove a bale-clasp SFP or SFP+ module from a module port in a blade, do the following: Remove the cable connected to the SFP or SFP+ module, if any. Open the bale clasp on the module with
Guide Hardware Installation Guide for Cisco NCS 1010 and
Perform the replacement or upgrade of the modules (Online Insertion or Removal (OIR)) only when the ambient temperature is below 30-degree
Guide How to Install and Remove Optical Modules Safely
Install optical modules safely with ESD protection, proper handling, and dust control. Follow these steps to avoid damage and ensure network reliability.
Guide Replacing an Optical Module
Identify the optical fibers to be connected to the optical module. Remove the dust caps from the optical fibers and insert the optical fibers to the bores of the optical module.
Guide How to Install and Remove SFP Transceiver Modules?
SFP transceivers allow for the transmission and reception of optical signals in networking devices such as switches, routers, and media converters. In this guide, we will walk you through the
Guide Optical Transceiver Module Installation And Removal Guide
Pull out the optical module in the horizontal direction (please use even force when pulling out to avoid damaging the handle), and cover the optical module slot with a dust-proof cap.
Guide How to remove the module | FS
When the optic transceiver gets stuck, you can hold the Optic Transceiver pull ring with your left hand, then pick it out with the tweezers. Please don''t force pull it out....more. FS...
Guide Remove an SFP+ or QFSP Optical Transceiver Module
For a dual-part module assembly, remove the optical transceiver module from the slot. Pull down the SFP+ or QSFP optical transceiver module latch into the open position.
Guide How to install and remove a optical transceiver
Pull out the pull ring of the optical module, keep the angle parallel to the port and pull out the optical module. Put the removed transceiver in an antistatic bag.
Guide Hardware Installation Guide for Cisco NCS 1010 and Cisco NCS 1000
Perform the replacement or upgrade of the modules (Online Insertion or Removal (OIR)) only when the ambient temperature is below 30-degree Celsius. Complete the OIR of modules within